Loading ...
Loading ...
Loading ...
21
Installation
OPTION B PRE-WIRED INSTALLATION
1. Cut the end of the safety reversing sensor wire, making sure there is enough wire to reach the
pre-installed wires from the wall.
2. Separate the safety reversing sensor wiresand strip 7/16 inch (11 mm) of insulation from each
end.Choose two of the pre-installed wires and strip 7/16 inch (11 mm) of insulation from each
end.Make sure that you choose the same color pre-installed wires for each sensor.
3. Connect the pre-installed wires to the sensor wireswith wire nuts making sure the colors
correspond for each sensor.For example,the white wire would connectto the yellow wire and
the white/blackwire would connect to the purple wire.
4. Atthe garage door opener,strip 7/16 inch (11 mm) of insulation from each end ofthe wires
previouslychosen for the safety reversing sensors.Twistthe like-colored wires together.
5. Insert the wires connected to the white safetysensor wires to the white terminal on the garage
door opener.Insert the wires that are connected to the white/blacksafety sensor wires to the
greyterminal on the garage door opener.
Safety reversing
sensor wires
Pre-installed
wires
White
White/Black
Yellow (for example)
Purple (for example)
Not Provided
Pre-installed wires
Safety reversing
sensor wires
7/16" (11 mm)
Yellow
Purple
1
3
4
7/16"
(11 mm)
2
WHITE
WHITE
RED
GREY
Purple
(for
example)
Yellow
(for example)
To insert or remove the wires from
the terminal, push in the tab with a
screwdriver tip.
5
Loading ...
Loading ...
Loading ...