Loading ...
Loading ...
Loading ...
Rinnai Australia 3 Operation Manual
USING WIRELESS WATER CONTROLLERS
ABOUT THE WIRELESS WATER CONTROLLER (MC-503RC)
TURNING ON THE WATER HEATER.
When the water heater is in the ‘Off’ condition only the communications
and battery status indicators are displayed on the digital monitor.
To turn the water heater ‘On’, press the On/Off button once (if Child lock
is activated see page 4). The communications indicator will briefly
illuminate to confirm that a signal has been sent to the transceiver
connected to the water heater.
The transfer indicator and the water temperature display will flash until
communication between the controller and transceiver is complete. When
the display stops flashing the water heater is ready to supply hot water.
ADJUSTING TEMPERATURE
Simply press the 'hot water temp' or buttons until the required
temperature is displayed on the digital monitor. The water temperature
and any active status indicator will flash until communication
between controller and transceiver is complete. DO NOT open the hot
water tap until the flashing stops and the desired temperature is displayed.
To operate the water heater, open any hot water tap. This will
automatically light the burner, providing hot water. The ‘In Use’ indicator
will illuminate on the water controller.
Once the hot water is running, if the set temperature is either too hot or
cold press the or buttons until the desired temperature is reached.
Whilst hot water outlets are open the set temperature may be
lowered to a minimum of 37°C. For safety, it cannot then be
raised above 43°C until all hot water taps are closed.
If the water heater is turned ‘Off’ whilst hot water taps are
open it can not be turned back ‘On’ until all hot water taps
have been closed.
Always check water temperature at the outlet before use.
A parent or carer should always check the temperature
before a child is placed in contact with hot water, see page 1.
Used to start and stop the Smartstart® preheat
unit (when fitted).
See Smartstart® Operation on page 6.
PREHEAT BUTTON
Used to switch the water heater on and off.
.
ON/OFF BUTTON
Used to transfer control priority between the
water controllers. The controller with priority
has command of the hot water delivery
temperature.
TRANSFER BUTTON
These buttons are used to select the water
temperature.
WATER TEMPERATURE
UP AND DOWN BUTTONS
Used to switch Child Lock function on and off.
CHILD LOCK BUTTON
Full battery indicator.
Low battery indicator.
Replace battery indicator, when flashing.
BATTERY STATUS
WATER HEATER 'In Use' INDICATOR
Indicates that the water heater is in operation
and delivering hot water.
Signal strength indicator
Strong signal Weak signal
Outofrangeindicator
Communications indicator
COMMUNICATIONS STATUS
Indicates the selected hot water temperature.
WATER TEMPERATURE INDICATOR
This indicator illuminates when the water
controller is in control of water delivery
temperature.
This indicator illuminates when the
Smartstart® preheater (when fitted) has
been activated.
This Child Lock indicator illuminates when
the child lock has been activated.
WATER CONTROLLER
STATUS INDICATORS
Ready to use
HOTHOT
COLDCOLD
ON!ON!
Ready to use
NOTE
CAUTION
Loading ...
Loading ...
Loading ...