Loading ...
Loading ...
Loading ...
5. Route cable up through the top of the tower frame and down through the side tube of the frame.
Item Description Qty.
1 Cable 1
6. Install screws, washers, spacers, and nuts securing the pulleys to the top of the tower frame using an 8mm Allen wrench and
17mm wrench.
NOTE: Make sure the spacers are centered and inside the tube wall.
Item Description Qty.
1 Pulley, 3.5" OD 1
2 Pulley, 4.5" OD 1
3 Cable 1
4 Screw, M10 x 1.5, 55mm 2
5 Nut, M10 x 1.5, Hex Nylock 2
6 Washer, Flat 3/8" ID 4
7 Bushing 4
Tighten hardware to 14-16 (19-21.7 Nm).
NOTE: Make sure cable is routed over the pulleys and underneath the pins in the tower frame.
7. Flex rear shroud into position inside the tower frame.
Page 15 of 36
Loading ...
Loading ...
Loading ...