Loading ...
Loading ...
Loading ...
11
Power Amplifier
How to Connect using a single Amplifier
Spade Lug or Wire Connections:
10. Referring to the illustration connect the Loud-
speaker hookup cables to the XR100 Negative (-)
Input Terminal and Positive (+) Input Terminal.
Insert the spade lug connector or prepared section
of the cable end into the Input Terminal side access
hole, and tighten the Input Terminal cap until the
cable is firmly clamped into the terminals so the
lugs or wire cannot slip out. Refer to figures 15
and 16.
Note: It is important to maintain the correct polar-
ity at both ends of the Loudspeaker cables.
11. Connect the other end of Loudspeaker cables
coming from the XR100 Negative (-) LOW Input
Terminal to the Left Channel COM (-) 8 Ω Output
Terminal of the Amplifier.
12. In a similar manner, connect the Loudspeaker
cables coming from the second XR100 Positive (+)
LOW Input Terminal to the Left Channel 8 Ω (+)
Output Terminal of the Amplifier.
13. Connect the second XR100 Loudspeaker in a
similar manner to the Amplifiers Right Channel
Terminals.
Figure 15
Figure 16
XR100
Right Channel
XR100
Left Channel
Jumper
Jumper
Jumper
Jumper
Loading ...
Loading ...
Loading ...