Loading ...
Loading ...
Loading ...
10
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM COLLECTION TANK.
MAINTENANCE
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum. (Fig. 2)
3. Undo the latches and remove the power head from the collection tank. (Fig. 3)
4. Clear all dirt or debris from the collection tank and hose. (Fig. 4)
5. Clean or replace the lters.
6. Check the hose, attachments and the power cord to ensure that they have not been damaged.
7. Place power head back on collection tank and secure latches.
IMPORTANT! Clean or change the cartridge lter regularly for best performance. ALWAYS USE
CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the cartridge lter,
the motor will burn out and the warranty will be voided. Always keep spare lters on hand.
NOTICE! The lters included are made of high quality materials designed to stop small dust
particles. The cartridge lter should be used for dry pick-up only. A dry cartridge lter is necessary
to pick up dust. If the cartridge lter is wet, it will clog quickly and be very difcult to clean. Handle
the lter carefully when removing it for cleaning and replacing it. Check the lters for tears or small
holes. A small hole can let dust pass through and out of the lter. Do not use a lter with holes or
tears; replace it immediately.
1 2 3 4
Emptying the Collection Tank
6. Verify that the power switch is in the ‘O’ OFF position before plugging the power cord into the
outlet. (Fig. 4 & 5)
7. Before turning ON the vac, rmly hold the loose end of the hose. Turn the motor on by pressing
the switch to the ‘I’ ON position. (Fig. 6)
8. Once you have completed blowing, ip the power switch to the 'O' (OFF) position and unplug
the power cord from the outlet. (Fig. 7)
Loading ...
Loading ...
Loading ...