Loading ...
Loading ...
Loading ...
29-6066
7
CARE AND CLEANING: Filters
Filters (Pyramid Models JVW5301, JVW5361)
Be sure the circuit breaker is off and all surfaces are cool before cleaning or servicing any part of the vent hood.
Metal Grease Filter
The metal filters trap grease during cooking.
The filter must ALWAYS be in place when the hood is in
use. The grease filter is dishwasher-safe and should be
cleaned every 6 months, or as needed.
To remove:
Pull downward on the filter lock to release the filter.
To replace:
Fit the tabs at the bottom of the filter into the slots in the
back of the filter opening. Lift up the front side of the filter
and push gently until the filter locks into place. Make sure
the filter lock is in the closed position to secure the filter.
To clean, swish the filter in hot soapy water and rinse
in clean water or wash it in the dishwasher. Do not use
abrasive cleansers.
NOTE: Some discoloration may occur in the dishwasher.
For Recirculation Installation Only
Charcoal Filter (Not Included)
If the model is not vented to the outside, the air needs to
be recirculated through a disposable charcoal filter that
helps remove smoke and odors.
NOTE: DO NOT rinse, or put charcoal filter in an
automatic dishwasher.
The charcoal filter cannot be cleaned. It must be
replaced. It is recommended that the charcoal filter
be replaced every 6-12 months or if it is noticeably
dirty or discolored.
Order Charcoal Filter JXCF72.
To inquire about purchasing replacement charcoal filters,
contact your local GE Appliances dealer or authorized
GE parts distributor.
To install:
1. Remove the metal filters—see Metal grease filter
section.
2. Place the side of the charcoal filter with the tabs
against the side of the blower.
3. Align the double lines on the charcoal filter with the
"unlocked" symbol on the blower.
4. Push and twist the charcoal filter downward until the
double lines align with the "locked" symbol on the
blower.
5. Repeat with second filter on the other side of the
blower.
6. Replace the metal filters—see Metal grease filter
section.
To remove:
1. Remove the metal filters—see Metal grease filter
section.
2. Twist the charcoal filters upward on both sides of the
motor to align the double lines with the "unlocked"
symbol. The locks are now disengaged and the
charcoal filters can be removed.
NOTE: The 30"
(76.2 cm) models
have 2 grease filters.
The 36" (91.4 cm)
models have 3 grease
filters.
Loading ...
Loading ...
Loading ...