Loading ...
If multiple incorrect PIN codes or fingerprints are entered, the safe will lock for a "time-out"
period of 2 minutes. The LCD will read “HOLD-Err”.
Test the keys and store them in a secure place, NOT inside of the safe.
When the screen shows “ ”, please change the battery. All registered fingerprints and PINs
will be saved.
Firearm Warning
Never store firearms and ammunition together. Always store them separately in locking
containers or cabinets. Make sure that your firearm is not loaded when stored. Be aware of
federal or local regulations governing firearm storage.
OPERATING INSTRUCTIONS
1. Before first use
1.1 Unlock the safe with key. Keyhole is located under the logo plate. Remove the plate using
the Allen key.
1.2 Install 4 AA batteries in the compartment.
2. How to reset safe to factory default settings
PRESS and HOLD down red button for 10 seconds. ”INIT” flashes on LCD display followed by
“OK”. Safe is reset to factory default. All data is deleted and you can begin new registration when
red light comes on.
3. How to register fingerprints on fingerprint scanner
3.1 To register a fingerprint, PRESS the red button BRIEFLY. As soon as red light comes on, press
your finger on the glass fingerprint scanner. LCD screen will display “OK”. Battery indicator
and data count indicator “ld--01” will display.
3.2 If the registration fails, “Err” will be displayed on LCD screen. Register the same finger again
by repeating Step 3.1
3.3 Repeat Step 3.1 with the same finger but at a different position on the glass (left, right, up,
down, to the side.)
Note: It is advisable to register multiple fingerprint variations using at least two fingers. The
more variations you program, the less likely you will be to encounter any problems opening the
safe quickly in an emergency.
3.4. To register a completely different fingerprint, repeat Step 3.1.
4. How to register/change PIN code
Note: The factory default PIN 1234.
4.1 Using the keypad, enter I234 and HOLD DOWN star button (*) until underscore (_) is
displayed on the LCD screen.
4.2 Immediately enter in a new PIN code, consisting of 4 – 8 digits, and press the star button (*).
Underscore (_) is displayed again. Enter the new PIN again and press star button (*) again.
An “OK” will display after the PIN is entered twice. New PIN is registered. Test with new
PIN as well as with old PIN.
5. How to unlock and lock the safe with your fingerprint
5.1 Unlock: Press pound button (#). When red light comes on, press your finger onto the glass
fingerprint scanner. The battery indicator and data count indicator “ld--01” will display on
the LCD screen. Safe will unlock.
5.2 Lock: Close the door. Press either the star button (*) or the pound button (#).
2
Loading ...
Loading ...