Loading ...
Loading ...
Loading ...
The quantity Lamp you selected flashes
when you press the START button.
TROUBLESHOOTING
Make sure that the Tea Mortar is set correctly.
Remove the Tea Mortar, and then place it back
on the receiver unit properly and press the
START button.
E.g.: Suppose you want to grind tea
leaves for 1 cup.
Cooling time (max.)
1cup : 3min 20sec, 2cups : 6min 30sec,
3cups : 9min 40sec, 4cups : 12min 50sec,
MAX : 30min
The Quantity Lamp flashes when you
press the GRIND button.
E.g.: Suppose you want to grind tea
E.g.: Suppose you want to select “HOT”.
“MAX” and “LATTE” are flashing.
leaves for 4 cups.
(This indicates you are unable to grind
tea leaves for 4 cups/MAX)
Mode lamp you selected flashes when
you press the START button.
Make sure that the container is set correctly.
Remove the container, place it back into the main
unit properly and then press the START button.
There is no water in the Water Reservoir.
Press the STOP button and remove the water
reservoir. Fill the water reservoir and insert it back
into the main unit and re-program.
All Quantity Lamps are flashing and
the Tea Maker stops.
Upper mortar unit and lower mortar may be stuck
together. See page E-19 for maintenance directions.
All lamps light up in sequence.
The Tea Maker does not work when
you press the START button.
The Tea Maker is in demonstration mode.
This feature is mainly for use by retail outlets,
and only allows for trial operation.
To cancel, press and hold the STOP button until
it beeps and then press it 4 times.
If you notice unusual flashing lights and you believe that the Tea Maker is not working properly, check the chart
below before consulting a Sharp Authorized Servicer.
This will help prevent unnecessary service calls.
DISPLAY
ANSWER
E-24
The Tea Mortar has overheated. Allow it to cool
down for the following time (depending on the
number of cups corresponding cups)
If you still require service, disconnect the plug from the outlet and CONTACT YOUR NEAREST SHARP
AUTHORIZED SERVICER.
ENGLISH
Loading ...
Loading ...
Loading ...