Loading ...
Loading ...
Loading ...
High Level Speaker Input (requires adapter)
Please contact Wet Sounds for information.
Auto Turn On Sense Capability
In auto sense mode when the deck turns on the amp’s microprocessor
will detect the deck’s output and automatically turn on the amp. Most
systems will utilize a blue remote turn on lead. However if you need
information on how to activate this feature, please contact Wet Sounds.
Marine Complaint
Rubber gasket covering crossover controls designed to keep moisture
away. Conformal coated pcb for protection against moisture. Completely
sealed design for no water intrusion.
Built In Raised Feet
The sinister amplifiers were designed with integrated raised side feet.
This gives easy access to pull wire under the amplifier. This also raises
the amplifier off the boats panel or carpet allowing air to circulate.
The Sinister amplifiers are designed for 4 AWG Power wire (+12 V) and
Ground wire (GND). You will need to prepare the wire by remove 5/8” on
the protective shielding on the power and ground wire. Then take an
allen tool and back out the screws on the terminal block +12 volt wire
into the +12V side of the terminal block and then tighten the screw back
into the terminal block. You will do the same for the Ground wire. Please
make sure you are using “positive” wire for the +12V. Also, please make
sure you are running the ground back to the battery when used in a
marine application. (in a car audio application, make sure to ground to
the chassis as close to the amp as possible). You will also be attaching
the Remote turn on. Labeled Turn ON” This is usually a blue wire from
the head unit.
6 FEATURES
POWER CONNECTIONS
7
Speaker Connections
The Sinister amplifiers are designed with a removable speaker plug.
These plugs were designed to accommodate larger wire (12 ga) or
multiple wires. Please make sure if using smaller gauge wire, you strip
the wire back fold it over and solder the ends. You can attach the wire to
the amp with the terminals plugged in by using a flat head screw driver
and insert the stripped speaker wire and tighten down. Or remove the
speaker plugs from the amp by pulling them out. Attach your wires and re
insert into the amplifier once mounted. Making sure to follow the
markings for + and -. There is also a silk screened guide for bridging the
channels
SINISTER SERIES FRONT PLATE
SD2 Front Plate Screen
SD6 Front Plate Screen
SD4 Front Plate Screen
Loading ...
Loading ...
Loading ...