Loading ...
Loading ...
Loading ...
Operating the appliance en
29
Switching off the appliance
Shortly after the end of the
programme:
1. Switch off ON/OFF switch (.
2. Turn off water supply (does not
apply to appliances with Aqua-Stop).
3. Remove the utensils when they have
cooled down.
Note: When the programme ends,
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.
Interrupting the programme
Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
2. Switch on the ON/OFF switch (
again to continue the programme.
Terminating the programme
(Reset)
Ter minating the pr ogr amme
1. Press the START button P and
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window )". The
programme sequence lasts about
1 minute. The value ‹:‹‹ appears in
the display window )".
2. Switch off ON/OFF switch (.
Changing the programme
When the START button P has been
pressed, the programme cannot be
changed. The only way a programme
can be changed is by Cancel
programme (Reset).
ExtraDry
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Be careful if you have delicate
tableware)
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button P until •:‹...
appears in the display window )".
3. Release both buttons.
The LED of the # button flashes
and the digital display )" shows
the factory setting •:‹….
4. Press the programme button #
repeatedly until the factory setting
value š:‹‹ appears in the display
window )".
5. By pressing the 3 button you can
switch intensive drying on š:‹‚ or
off š:‹‹.
6. Press START button P.
The set value is saved.
Loading ...
Loading ...
Loading ...