Loading ...
Loading ...
Loading ...
Water softening system/special salt en
13
Adjusting the water softening
system
You can set the amount of salt that
should be added to a value between
•:‹‹ and •:‹ˆ. No salt is needed with
the setting •:‹‹.
Here’s how to set up the amount of
added salt:
1. Ask your local water utility company
for the water hardness value of the
tap water.
2. Required setting can be found in the
water hardness table.
3. Switch on ON/OFF switch (.
4. Hold down the programme button
# and then repeatedly press the
START button P until •:‹...
appears in the display window.
5. Release both buttons.
The LED of the # button flashes
and the digital display )" shows
the factory setting •:‹….
6. Press the programme button 3.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value •:‹ˆ the
display jumps back to •:‹‹ (Off).
7. Press START button P.
The chosen setting has now been
stored in your dishwasher.
Using special salt
Top up the special salt as soon as the
salt refill indicator ` lights up in the
control panel. Always top up the special
salt immediately before switching on the
dishwasher. This ensures that overrun
special salt solution is immediately
rinsed out and that corrosion in the
washing tank cannot occur.
Caution!
Detergent will destroy the water
softening unit! Never pour detergent into
the dispenser for special salt.
Top up the special salt as follows:
1. Undo the screw plug on the
dispenser 1R.
2. Fill the dispenser with water
(required only when switching on the
appliance for the first time).
3. Add special salt as illustrated (do
not use table salt or tablets).
The water is displaced and runs out.
*Depending on the features of your
dishwasher
Using detergent with a salt
component
De t e r g e n t wi t h a sal t component
In general, you can use detergent with
a salt component up to a water
hardness level of 21 °dH (37 °fH, 26
°Clark, 3.7 mmol/L) without adding
special salt. Above a water hardness
value of 21 °dH, use additional special
salt.
Switching off salt refill
indicator/water softening unit
Swi t c h i n g of f wa t e r sof t eni ng uni t
If the salt refill indicator ` bothers
you (e.g. if you are using a combination
detergent with a salt component), you
can switch off the salt refill indicator.
Proceed as described under "Setting
water softening unit" and set the value
to •:‹‹. The water softening unit and
the salt refill indicator are switched off.
Loading ...
Loading ...
Loading ...