Loading ...
Loading ...
Loading ...
16
Wait until the moisture condensation at the
lens has cleared.
Replace or clean the disc.
8VHDÀQDOL]HG&'RUFRUUHFWIRUPDWGLVF
&DQQRWGLVSOD\VRPHÀOHVLQ86%GHYLFH
7KHQXPEHURIIROGHUVRUÀOHVLQWKH86%
device has exceeded a certain limit. This
phenomenon is not a malfunction.
7KHIRUPDWVRIWKHVHÀOHVDUHQRWVXSSRUWHG
USB device not supported
The USB device is incompatible with the unit.
Try another one.
Poor radio reception
Increase the distance between the unit and
your TV or VCR.
Fully extend the FM antenna.
Connect an outdoor FM antenna instead.
Timer does not work
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
9 Troubleshooting
Warning
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the
system yourself.
If you encounter problems when using this apparatus,
check the following points before requesting service. If
the problem remains unsolved, go to the Philips web
site (www.philips.com/welcome). When you contact
Philips, ensure that the apparatus is nearby and the
model number and serial number are available.
No power
Ensure that the AC power cord of the unit is
connected properly.
Ensure that there is power at the AC outlet.
As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control is
operated.
No sound or poor sound
Adjust the volume.
Disconnect the headphones.
Check that the speakers are connected
correctly.
Check if the stripped speaker wires are
clamped.
No response from the unit
Disconnect and reconnect the AC power plug,
then turn on the unit again.
As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control is
operated.
Remote control does not work
%HIRUH\RXSUHVVDQ\IXQFWLRQEXWWRQÀUVW
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the unit.
Insert the battery with its polarities (+/– signs)
aligned as indicated.
Replace the battery.
Aim the remote control directly at the sensor
on the front of the unit.
No disc detected
Insert a disc.
Check if the disc is inserted upside down.
EN
DCM377_05_UM_V1.1.indd 16 2010-9-29 16:46:55
Loading ...