Loading ...
Loading ...
Loading ...
37
WATER SOFTENER FILTER
Certain models are fitted with a water softener filter. If this is not the case with
your model, you are recommended to purchase one from an approved supplier.
To use the filter correctly, follow the instructions below.
Installing the filter
1
Remove the filter from the packaging.
2
Press .
3
Press or until WATER FILTER appears on the display.
4
Press .
5
TURN DATE INDICATOR TO DISPLAY NEXT 2 MONTHS:
turn the date indicator disk until the next two months
of the year are displayed. Press NEXT.
Note: the filter lasts about two months if the appliance is used normally. If
the coffee maker is left unused with the filter installed, it will last a maximum of
three weeks.
1
RUN WATER INTO FILTER HOLE UNTIL
IT COMES OUT FROM OPENINGS:
To activate the filter, run tap water
through the hole in the filter as shown
in the figure until water comes out of
the openings at the side for more than
a minute. Press NEXT.
2
Extract the tank from the appliance
and fill with water.
3
IMMERSE FILTER IN THE WATER TANK
LETTING AIR BUBBLES ESCAPE.
Place the filter in the water tank
immersing it completely for about
ten seconds, allowing air bubbles
to escape. Press NEXT.
4
Insert the filter into the filter housing
and press as far as it will go.
Press NEXT.
5
INSERT WATER TANK: Close the tank
with the lid, then place the tank back
into the appliance.
6
PLACE 2L CONTAINER UNDER SPOUTS,
press TO FILL FILTER: Container has
to hold at least 0.5L Delivery begins
and stops automatically. The symbol
appears on the display alongside the
time to indicate that the filter has been
enabled.
You can now use the coffee maker.
Loading ...
Loading ...
Loading ...