Loading ...
Loading ...
Loading ...
en Faults and what to do about them
40
Residual water in the
care-product compart-
ment i.
■ Not a fault – the effect of the care product is not impaired.
■ Clean the insert if necessary.
Odours or greasy depos-
its in the washing
machine.
Depending on the model, run the Drum Clean* or Cottons 90 °C programme
without laundry.
Add washing powder or a detergent containing bleach.
Note: To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents designed for wool or del-
icates.
The Å symbol lights up
in the display panel. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent? ~ "Foam detection" on page 30
Loud noises, vibrations
and machine "move-
ment" during the spin
and/or drain cycles.
The noise level during pumping is different from the one during washing.
■ Is the appliance aligned? Align the appliance. ~ Page 17
■ Are the appliance's feet secured? Secure the appliance's feet. ~ Page 17
■ Have the transport locks been removed? Remove the transport locks.
~ Page 14
The display panel/indica-
tor lights do not work
while the appliance is run-
ning.
■ Has there been a power cut?
■ Have the fuses blown? Reset/replace the fuses.
■ If the fault occurs repeatedly, call the after-sales service. ~ Page 41
There is detergent resi-
due on the laundry.
■ Some phosphate-free detergents contain water-insoluble residue.
■ Select Rinse or brush the laundry after washing.
The è symbol lights up
in the display in pause
mode.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
■ Press the Start Reload A button to continue the programme.
In the pause mode, the è
symbol in the display
goes out.
The door is unlocked. It is possible to add laundry.
If you cannot rectify a fault yourself (after switching the machine off and on again) or a repair is required:
■ Switch off the appliance and disconnect the mains plug.
■ Turn off the tap and call the after-sales service. ~ Page 41
Faults Cause/Remedy
* depending on the model
Loading ...
Loading ...
Loading ...