Loading ...
Loading ...
Loading ...
en Positioning and connecting
18
Note: The washing machine must be
correctly installed and connected.
~ Page 12
1. Check the appliance.
Note: Never use a damaged
machine. Inform the after-sales
service.
2. Remove the protective foil from the
worktop and the control panel.
3. Connect the mains plug.
4. Turn on the water tap.
5. Do not load any laundry. Close the
door.
6. Depending on the model, run the
Drum Clean
*
or Cottons 90 °C
programme.
7. Open the detergent drawer.
8. Pour approximately 1 litre of water
into compartment II.
9. Pour standard detergent into
compartment II.
Note: To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer. Do not use detergents
designed for wool or delicates.
10.Close the detergent drawer.
11.Press the Start Reload A button.
12.When the programme ends, switch
off the appliance.
Your washing machine is now ready to
use.
Transportation
e.g. when moving home
Preparatory work:
1. Turn off the water tap.
2. Reduce the water pressure in the
supply hose.
~ "Filter in the water supply is
blocked" on page 36
3. Drain the remaining detergent
solution.
~ "Drain pump is blocked"
on page 35
4. Disconnect the washing machine
from the mains.
5. Remove the hoses.
Installing the transport locks:
1. Remove the covers and keep them
in a safe place.
Use a screwdriver if necessary.
2. Insert all four sleeves.
Clip the mains cable securely in the
holders. Insert and tighten the
screws.
Before switching on the appliance
again:
Notes
■ The transport locks must be
removed.
~ "Removing the transport locks"
on page 14
■ To prevent unused detergent from
flowing straight into the drain during
the next wash: Pour approx. 1 litre of
water into compartment II and start
the Drain/Empty programme.
* depending on the model
Loading ...
Loading ...
Loading ...