Loading ...
Loading ...
Loading ...
10
USING YOUR PROSCENIC APPLIANCE
PLEASEREAD THE'IMPORTANT SAFETY INSTRUCTIONS' IN THIS PROCENIC
OPERATING MANUAL BEFORE PROCEEDING
OPERATION
• Do not use outdoors or on wet surfaces or to vacuum water or other liquids –
electric shock coul d occur.
• Ensure the appliance remains upright in use and in storage. Dirt and debris may
be released if it is turned upside down.
• Do not operate while checking for blockages.
•
•
For domestic indoor and car use only. Do not use it whilst the car is in motion or
while driving.
• Use appropriate mounting hardware for your wall type an
d ensure that the
wall bracket is mounted securely. Ensure no pipe work (gas, water, air) or
electrical cables, wires or ductwork are located directly behind the mounting
area. The docking station must be mounted in accordance with regulations
and applicable codes/standards (state and local laws may apply). proscenic
recommends the use of protective clothing, eyeware and materials when
installing the docking station.
CARPETS OR HARD FLOORS
• Before vacuuming your ooring, rugs and carpets, check the manufacturer's
recommended cleaning instructions.
• The brush bar on the appliance can damage certain carpet types and oors.
Some carpets will fuzz if a rotating brush bar is used when vacuuming. If this
happens, we recommend vacuuming without the motorised oor tool and
consulting with your ooring manufacturer.
• Before vacuuming highly polished oors, such as wood or lino, rst check that
the underside of the oor tool and its brushes are free from foreign objects that
could caus e marki
ng.
LOOKING AFTER YOUR PROSCENIC APPLIANCE
• Do not carry out any maintenance or repair work other than that shown in this
Prosenic Operating Manual, or advised by the proscenic Helpline.
• Only use parts recommended by Prosenic. If you do not this could invalidate
your guarantee.
• Store the appliance indoors. Do not use or store it below 3°C (37.4°F). Ensure
the appliance is at room temperature before operating.
• Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning
agents, polishes or air freshen
ers on any part of the appliance.
VACUUMING
• Do not use without the clear bin and lter in place.
• Fine dirt such as our should only be vacuumed in very small amounts.
• Do not use the appliance to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the appliance.
• When vacuuming, certain carpets may generate small static charges in the
clear bin or wand. These are harmless and are not associated with the mains
electricity supply. To minimise any eect from this, do not
put your hand or
insert any object into the clear bin unless you have rst emptied it. Clean the
clear bin with a damp cloth only. (See ‘Cleaning the clear bin’.)
• Use extra care when cleaning on stairs.
• Do not rest the appliance on chairs, tables, etc.
• Do not press down on the nozzle with excessive force when using the appliance
as this may cause damage.
• Do not leave the cleaner head in one place on delicate oors.
• On waxed oors the movement of the cleaner head may create an uneven
lustre. If t
his happens, wipe with a damp cloth, polish the area with wax, and
wait for it to dry.
EMPTYING THE CLEARBIN
• Empty as soon as the dirt reaches the level of the Dust bin mark – do not overll.
• Ensure the appliance is disconnected from the charger before emptying the
clear bin. Be careful not to pull the 'ON' trigger.
• To make emptying the clear bin easier, it is advisable to remove the wand and
oor tool.
• To release the dirt, push the blue button by the clear bin: Press once to open the
bin base.
• To minimis
e dust/allergen contact when emptying, encase the clear bin tightly in
a plastic bag and empty.
• Remove the clear bin carefully from the bag.
• Seal the bag tightly, dispose as normal.
• Close the clear bin base so it clicks into place and is secure.
CLEANING THE CLEAR BIN
• Ensure the appliance is disconnected from the charger before removing the
clear bin. Be careful not to pull the ‘ON’ trigger.
• Remove the wand and oor tool.
• Remove the clear bin carefully.
• Clean the clear bin with a damp cloth o
nly.
• Do not use detergents, polishes or air fresheners to clean the clear bin.
• Do not put the clear bin in a dishwasher.
• Clean the cyclone shroud with the brush on the combination tool to remove lint
and dust.
• Ensure the clear bin is completely dry befor e replacing.
• To replace the clear bin, push the clear bin up and in to the main body of the
appliance. It will click into place.
• Close the clear bin base so it clicks into place and is secure.
WASHING YOUR FILTER
• Ensure the appliance is disconnected from the charger before removing the
lter. Be careful not to pull the ‘ON’ trigger.
• Your appliance has one washable lter, located as shown.
• To remove the lter, lift it out of the top of the appliance.
• Check and wash the lter regularly according to instructions to
maintain performance.
• The lter may require more frequent washing if vacuuming ne dust or if used
mainly in ‘Powerful suction’ mode.
• Wash the lter with cold water only.
• Run water over the outside of the lter until the water r
uns clear.
• Squeeze and twist with both hands to make sure the excess water is removed.
• Lay the lter on its side to dry. Leave to dry completely for a minimum of
24 hours.
• Do not put the lter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near a naked ame.
• To ret, place the dry lter back into the top of the appliance. Make sure it is
seated properly.
LOOKING FOR BLOCKAGES
• Ensure the appliance is disconnected from the charger before looking for
blockages. Be careful not to pu
ll the ‘ON’ trigger.
• Do not operate while checking for blockages. Failure to do so could result in
personal injury.
• Beware of sharp objects when checking for blockages.
• To gain access to blockages in the oor tool, remove the base plate by using a
coin to loosen the screw marked with a padlock.
• If you cannot clear an obstruction you may need to remove the brush bar. Use
a coin to unlock the fastener marked with a padlock. Remove the obstruction.
Replace the brush bar and secure it by tig
htening the fastener. Ensure it is xed
rmly before operating the appliance.
• This product has carbon bre brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
• Ret all parts securely before using.
• Clearing blockages is not covered by your guarantee.
BLOCKAGES–THERMAL CUT-OUT
• This appliance is tted with an automatically resetting thermal cut-out.
• Large items may block the tools or nozzle. If any
part becomes blocked the
appliance may overheat and automatically cut-out.
• Leave to cool down for 1-2 hours before checking the lter or for blockages.-
• Ensure the appliance is disconnected from the charger before looking for
blockages. Failure to do so could result in personal injury.
• Clear any blockage before restarting.
• Ret all parts securely before using.
• Clearing blockages is not covered by your guarantee.
CHARGING AND STORING
• This appliance will switch ‘OFF’ if the battery temperature is below 3°C (37.4°F).
This is designed to protect the motor and battery. Do not charge the appliance
and then move it to an area with a temperature below 3˚C (37.4°F) for
storage purposes.
• To help prolong battery life, avoid recharging immediately after a full discharge.
Allow to cool for a few minutes.
• Avoid using the appliance with the battery ush to a surface. This will help it run
cooler and prolong battery run time and life.
BATTERY SAFETY INSTRUCTIONS
• If the battery needs replacing please contact the proscenic Helpline.
• Use only proscenic chargers for charging this proscenic appliance.
• The battery is a sealed unit and under normal circumstances poses no safety
concerns. In the unlikely event that liquid leaks from the battery do not touch the
liquid and observe the following precautions:
– Skin contact – can cause irritation. Wash with soap and water.
– Inhalation – can cause respiratory irritation. Expose to fresh air and seek
medical advice.
– Eye contact – can cause irritation. Immedia
tely ush eyes thoroughly with
water for at least
inutes. Seek medical attention.
– Disposal – wear gloves to handle the battery and dispose of immediately,
following local ordinances or regulations.
CAUTION
The battery used in this device may present a risk of re or chemical burn if
incinerate. Keep away from children. Do not disassemble and do not dispose of
in re.
DISPOSAL INFORMATION
• proscenic products are made from high grade recyclable materials. Recycle
where possible.
• The battery should be removed from the product before disposal.
• Dispose of or recycle the battery in accordance with local ordinances
or regulations.
Diagnostics – battery
When in use, trigger pressed(lightoncleaner)：
3solidbluelight:ON
1ashingbluelight:Nopower
When charging battery(lightonbattery):
solidredlight:charging
solidbluelight:chargingcomplete
redlight/bluelightexchangedshing:fault
This product has carbon fibre brushes. Take care if coming into contact with
them, as they may cause minor skin irritation. Wash your hands after handling
the brushes.
EN
WALL BRACKET INSTALLATION
Loading ...
Loading ...
Loading ...