Loading ...
Loading ...
Loading ...
(138,1)
北米Model "A8240BE-E" EDITED: 2019/ 2/ 18
warning flashers flash five times to
alert you that the doors (or the rear
gate) are not properly closed. When
you close the door, doors will automa-
tically lock and the system will auto-
matically arm in 30 seconds.
5. Approximately 30 seconds later, the
system will enter surveillance state.
When the system is in surveillance state,
the security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
NOTE
. The system can be armed even if the
windows and/or moonroof are open.
Always make sure that they are fully
closed before arming the system.
. The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
– Doors (including the rear gate)
are unlocked using the access key
fob/remote transmitter.
– Doors (including the rear gate)
are unlocked using the keyless
access function (models with “key-
less access with push-button start
system”).
– Any door (including the rear gate
and engine hood) is opened.
– The ignition switch is turned to
the “ON” position (models without
“keyless access with push-button
start system”).
– Push-button ignition switch is
turned to the “ACC” position (mod-
els with “keyless access with push-
button start system”).
& Disarming the system
S02AF05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob/remote
transmitter.
. Carry the access key fob and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the rear gate opener button.
– Unlock using the PIN code access.
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
S02AF0501
If you cannot disarm the system using the
access key fob/transmitter (i.e., the trans-
mitter is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
The system can be disarmed if you turn the
ignition switch from the “LOCK”/“OFF”
position to the “ON” position with a
registered key/access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the ac-
cess key fob battery is discharged,
perform the procedure described in
“Switching power status” FP430. In
such a case, replace the battery im-
mediately. Refer to “Replacing battery
of access key fob” FP485.
& Alarm system setting
S02AF11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the system” FP136.
2. Sit in the driver’s seat and shut all
doors, the rear gate and engine hood.
3. Turn the ignition switch to the “ON”
Alarm system
136
Loading ...
Loading ...
Loading ...