Loading ...
Loading ...
Loading ...
42
DISPLAY POSSIBLE CAUSE WHAT TO DO
RINSE + all modifiers
A1: Water
Supply fault.
1 Ensure the water supply is
turned on.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Press
to resume the
wash program.
DELICATE, RINSE + all modifiers
A3: Drawer cannot
drain. The drainage
hose may be
blocked or kinked,
or the connection
to drainage pipe
may be blocked.
1 Ensure the drainage hose and
connection to pipes are not
blocked.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Press
to resume the
wash program.
FAST, DELICATE + all modifiers
A6: The spray
arm has loosened
or come off its
mounting, or
water pressure
is too low, or a
combination of low
water pressure and
excessive foaming.
1 Open the drawer and check the
spray arm.
2 If the spray arm has loosened
or come off its mounting,
re-fit it. Check that it is firmly
seated and turns freely.
Refer to 'Maintenance'.
3 Press
once to stop the beeping,
then again to clear the fault.
4 Press
to resume the
wash program.
FAST, DELICATE + RINSE
+ all modifiers
A7: Auto recovery
program –
DishDrawer™
Dishwasher has
detected excess
foam in the drawer.
1 Let the auto recovery program
run until it is complete. The
wash program will resume when
the auto recovery program
has completed.
2 Check that you are using the right
detergent before running another
wash program.
3 If the drawer is still filled with
foam at the end of the wash
program, contact Customer Care.
Current wash program +
SANITIZE
A09:
Sanitize
cycle hasn’t met
temperature
needed to
sanitize dishes.
1 Check if the water supply has
been turned off or the wash
program interrupted.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Run the sanitize cycle again.
FAULT CODES
‘A’ fault codes
Follow the steps below to try and fix the issue.
Loading ...
Loading ...