Loading ...
Loading ...
Loading ...
22
GB
Table of burner and nozzle specications
Table 1 Liquid gas Natural gas
BURNER
Diameter
(mm)
Heating
power
kW (H.s.*)
By-pass
1/100
(mm)
Nozzle
1/100
Nozzle
1/100
(mm)
Flow *
g/h
Flow *
l/h
(mm)Nomin. Red. G30 G31 G20
.3 Rapid
0100 3.00 0.7 40 86 218 214 116 286
.2 Semi-rapid
575 1.65 0.4 30 64 120 118 96 157
.1 Auxiliary
55 1.00 0.4 30 50 73 71 71 95
.4 Triple Ring 130 3.25 1.3 57 91 236 232 124 309
Gas oven 4.00 0.8 45 95 291 286 142 381
Supply pressure
Nominal (mbar)
Minimal (mbar)
Maximised (mbar)
28-30
20
35
37
25
45
20
17
25
* At 15°C and 1013 mbar - dry gas
Propane G31 P.C.S. = 50.37 MJ/Kg
Butane G30 P.C.S. = 49.47 MJ/Kg
Methane G20 P.C.S. = 37.78 MJ/m
3
Start-up and use
Using the hob
Lighting the burners
For each BURNER knob there is a complete ring showing
the strength of the ame for the relevant burner.
To light one of the burners on the hob:
1. Bring a ame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an anticlockwise
direction so that it is pointing to the maximum ame setting
.
3. Adjust the intensity of the ame to the desired level by
turning the BURNER knob in an anticlockwise direction.
This may be the minimum setting , the maximum setting
or any position in between the two.
The appliance is fitted with an
electronic lighting device which is
integrated into the knob. Simply light
the desired burner by turning the
corresponding knob in an anti-
clockwise direction, until it is aligned
with the large ame symbol, press
it all the way in to activate the
electronic ignition and hold it in that
position until the burner is lit. The burner might be extinguished
when the knob is released. If this occurs, repeat the process,
holding the knob down for a longer period of time.
! If the ame is accidentally extinguished, switch off the burner
and wait for at least 1 minute before attempting to relight it.
If the appliance is equipped with a ame failure safety device*,
press and hold the BURNER knob for approximately 2-3
seconds to keep the ame alight and to activate the device.
To switch the burner off, turn the knob until it reaches the
stop position ●.
Practical advice on using the burners
For the burners to work in the most efcient way possible and
to save on the amount of gas consumed, it is recommended
that only pans which have a lid and a at base are used.
They should also be suited to the size of the burner.
Burner
Fast (R)
Semi Fast (S)
Auxiliary (A)
Triple Crown (TC)
Ø Cookware Diameter (cm)
24 - 26
16 - 22
10 - 14
24 - 26
! Make sure the pans do not overlap the edges of the hob
while it is being used.
Loading ...
Loading ...
Loading ...