Loading ...
Loading ...
Loading ...
- Slide the steam control
(B) to the required
position (fig. 17).
• Just before the
watertank is emptied,
there normally is a
burst of steam and
possibly some minor
spitting. This is a
normal phenomenon,
related to the electrical pump.
Shot-of-Steam 9
By pushing button 9 (F)
a powerful "shot" of
steam is emitted from the
soleplate (fig. 18).
This can be very useful,
for example when
removing stubborn
creases.
The “shot-of-steam”
facility can be used only
while ironing with high
ironing temperatures (positions ranging from
2 to MAX) at an interval of
5 seconds.
Steaming in a vertical position
“Shot-of-steam” can also
be applied when holding
the iron in a vertical
position (fig. 19).
This is useful for
removing creases from
hanging clothes,
curtains, etc.
The "shot-of-steam”
facility can be used only
while ironing with high
ironing temperatures (positions ranging from 2
to MAX) at an interval of 5 seconds.
This iron is not suitable for continuous steaming
(except “shot-of-steam) in vertical position.
Ironing without steam
For ironing without steam, proceed as described
for steam-ironing. However, d not activate steam
trigger (C).
Calc cleaning eU
• Calc cleaning works in conjunction with anti-
calc.
- Calc cleaning allows to clean the steam
chamber from residual particles (dirt, sand,
etc.).
• For the best performances of the Philips
Aquazur it is important to apply calc cleaning
regularly. In case of normal usage
(2 hours/week), calc clean should be applied
once every month. In case of frequent usage
(average 4 hours/week), calc clean should be
applied once every two weeks.
- Bring the iron and watertank to the kitchen sink
(fig. 20).
- Fill the watertank (L) with water (to about half
tank).
- Plug in the power cord.
- Set the Temperature control (A) to position
'CALC CLEAN' (fig. 21). Set steam slider (B) to
position 4.
- If necessary, use the rubber mat to rest the iron
on the kitchen sink.
- Hold the iron horizontally over the sink.
- Push the 'CALC CLEAN' button eU (G) (fig.
22).
Water will now be ejected from the holes in the
soleplate. Impurities and scale (if any) are
washed away with it.
- Move the iron forwards and backwards while
this happens (fig. 23).
- Release the Calc-clean button eU to stop
the calc-clean process. Repeat the calc-clean
22
CALC CLEAN
21
23
19
;
;
20
18
8
17
CA
LC
CLEA
N
4
3
Loading ...
Loading ...
Loading ...