Loading ...
Loading ...
Loading ...
Spraying T
• You can spray at any temperature by pushing
on the spray button T (D) (fig. 15).
• An electrical pump in the iron stand supplies the
small internal reservoir (P) with spraywater.
• Ensure that there is enough water in the
watertank.
• When the internal reservoir (P) is empty, after
intensive spraying, pull the steam trigger (C) for
about one minute to refill it. Refilling is complete
when you see/hear steam coming out from the
steam vents on the iron sole.
• Filling and refilling of the internal reservoir must
be executed at a temperature setting between
2 and MAX. It’s not possible to fill the
reservoir at a temperature setting below 2
(fig. 16).
Steam-ironing
• As indicated on the temperature control (A) and
the table, steam-ironing is only possible at
higher ironing temperatures:
2 for moderate steam
3 for maximum steam.
• With conventional steam irons, water may leak
from the soleplate if a too low temperature has
been selected. This will cause stains.
However,the Philips Aquazur HI838, 835
features "Drip Stop" Steam Shut-off: the iron
will automatically stop steaming at too low
temperatures, to avoid the forming of drops,
which could leave stains on textile.
When Drip Stop is activated, you can hear
"Click". Set the temperature control (A) to the
advised position. Steaming will recommence as
soon as the appropriate temperature has been
reached.
• Ensure that there is enough water in the
watertank.
- Put the iron on its rubber mat on the watertank.
- Set the temperature control (A) at the required
position within the “steam area” (11 to MAX).
- Insert the mains plug into the wall socket.
- After the amber temperature pilot light (H) first
has gone out and has come on again, you can
start ironing.
polyester and 40% cotton” should be ironed at
the temperature indicated for polyester (1) and
without steam.)
If you do not know what kind(s) of fabric(s) the
article has been made of, find a spot which will
be invisible when wearing or using the article.
Try out the ironing temperature which is most
suitable there. (Start at a relatively low
temperature.)
• Pure woollen fabrics (100% wool) may be
pressed with the iron set to a steam position.
Preferably set the steam control to maximum
position and use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of
the fabric may occur. This can be prevented by
turning the article inside out and ironing the
reverse side.
• Velvet and other textures which rapidly acquire
shiny spots should be ironed in one direction
only (with the nap) applying light pressure.
Always keep the iron moving.
• Iron the reverse side of synthetic materials and
silk to prevent shining spots. Do not use the
spray button to prevent stains.
Setting the temperature
- Stand the iron on its
rubber mat on the
watertank.
- Set the temperature
control (A) to the
correct ironing
temperature as
indicated in the ironing
instructions or in the
table (fig. 14).
- Insert the mains plug
into the wall socket.
- After the amber temperature pilot light (H) first
has gone out and has come on again, you may
start ironing.
• The amber pilot light will come on from time to
time during ironing.
• If you set the temperature control to a lower
setting after ironing at a high temperature, do
not begin again before the amber pilot light has
come on and gone out again.
14
16
15
7
Loading ...
Loading ...
Loading ...