USER’S GUIDE - Page 6

Modied by

92/31/EEC

93/68/EEC

98/13/EEC and LVD 73/23/EEC modied by 93/68/EEC

This product meets safety standards:

EN60065:2002

UL6500 7th Edition: 2003

UL 60065 - STANDARD FOR AUDIO, VIDEO AND SIMILAR ELECTRONIC

APPARATUS - SAFETY EQUIREMENTS - Edition 7 - Revision Date 2007/12/11

CSA C22�2 NO 60065-03 - AUDIO, VIDEO AND SIMILAR ELECTRONIC

This device complies with Industry Canada’s licence-exempt RSSs� Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence�

L’exploitation est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage;

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement�

Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment�

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

of the FCC Rules� These limits are designed to provide reasonable protection against harmful interference in a residential

installation� This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction manual, may cause harmful interference to radio communications� However there is no

guarantee that the interference will not occur in a particular installation� If this equipment does cause harmful interference to

radio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

collect the interference by one or more of the following measures�

• Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

Section 3: EON ONE PRO System Declaration of Conformity