Loading ...
Loading ...
Loading ...
8
SAFETY INSTRUCTIONS
CAUTION
Unplug the power cord if the projector
is not used for a long period.
- Accumulated dust may cause
overheating, an electric shock from
corroded insulation and a fire from an
electrical surge.
Only use the specified type of battery.
- Otherwise, this may cause an electric
shock caused by overheating and
leakage.
Make sure you use the same type of
battery when replacing.
(Battery CR2032/ 3 V)
- In the case of a battery contact
failure, the battery may drain quickly
or the remote control may not work
properly.
Do not stare directly into lens when in
operation, eye damage can occure.
No user serviceable parts inside unit.
High voltage parts can cause shock
and even electrocution.
Proper ventilation required, do not
block airflow around unit.
Doing so can cause injury and
internal overheating.
To prevent damage to lamp, unit must
remain plugged in for approximately
3 minutes after power down to allow
for proper cool down (not applicable
on LED models).
Do not touch the lens; doing so can
result in burns or damage to lens.
Lens and unit may be HOT during
and immediately after use.
Use caution when handling unit,
allowing for proper cool down.
Only use a grounded electrical outlet.
Do not insert anything into or cover
up the exhaust vents.
Follow all maintenance guidelines for
optimal use; service only at an
authorized service center.
Lamp contains mercury and as such
must be disposed of according to
local, state and federal laws
(not applicable on LED models).
- This DLP Projector is a Risk Group
2 device that meets safety standard
IEC 62471 standard.
Loading ...
Loading ...
Loading ...