Loading ...
Loading ...
Loading ...
7
a
b
a Screws
b Hinge Cover
a
a
Wiring Harness
5.
Using an 8 mm socket wrench, remove
the three screws fastening the top
hinge to the cabinet.
a Screws
90°
a
Door Removal
(only if needed)
Measure the refrigerator to make sure it will fi t
through the doorway. If the refrigerator cannot
pass easily through the doorway, follow the
instructions to remove the two refrigerator
compartment doors and the front panel of the
freezer drawer.
WARNING
Electrical Shock Hazard
Disconnect power before removing doors.
Reconnect ground wire before operating.
Failure to do so could result in death or electric
shock.
Tools needed
•
Phillips Screwdriver
•
4 mm Hex-key Wrench
•
8 mm Socket Wrench
Remove the Doors
IMPORTANT: Keep the refrigerator doors closed
until you are ready to lift them from the cabinet.
1. Unplug refrigerator or disconnect power.
2.
Using a Phillips screwdriver, remove the
three
screws
attaching the hinge cover and
control
panel to the top of the cabinet.
3.
Gently lift the hinge cover, keeping the wire
harness attached, and move the cover/wire
harness assembly behind the door hinges on
the cabinet top.
4.
Disconnect the harness from the door by
using a release clip on the harness
connector, then separate the two ends(only
the left side).
8. Using both hands, lift the door off the bottom
hinge and set it onto a soft surface to protect
the fi nish.
NOTE: Provide additional support for the
door while the hinge is being removed. Do not
depend on the door gasket magnets to hold
the door in place while you are working.
6. Remove the top door hinge.
IMPORTANT: For the door to close properly
in the future, DO NOT lift the door from the
bottom hinge if it is open to an angle narrower
than a 90° angle.
7. Open the door to a 90° or wider angle.
Loading ...
Loading ...
Loading ...