Loading ...
Loading ...
Loading ...
Version Hi-Lo SS 3/08 - Page 7
INSTALL THE RANGEHOOD
1. Remove the rangehood from the carton and place on a
at surface. Cover the surface to prevent accidental damage.
Remove all parts including the backdraft damper, plastic grille
and literature package before discarding the carton.
2. Remove the grease lters from the rangehood and set
aside. The grease lters are removed by pressing the handle
of the lter as indicated in FIGURE 6. When replacing, make
sure that the lters are properly positioned with the handles
in front and visible.
MAKE YOUR CUT-OUTS
1. Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear
wall. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center
line on the cabinet where the rangehood will be installed.
3. Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the rangehood.
4. Determine the proper location for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Install the
cable. Use caulking to seal around the hole. DO NOT turn
on the power until installation is complete.
5. Make the cut-out opening where the rangehood will be
installed (FIGURE 5).
FIGURE 5
CUT-OUT
27 5/8"
13 5/32"
FIGURE 6
3. Place the round damper into the exhaust opening of
the rangehood and press down.
4. The rangehood mounts to the cabinet by two spring
loaded brackets, one on each side of the rangehood. Lift
the rangehood into the cutout opening in the cabinet. Be
careful not to damage the cabinet, rangehood or other ap-
pliances.
5. Tighten the rangehood to the cabinet by rotating the
screws indicated in FIGURE 7 with a phillips screw driver.
FIGURE 7
6. Remove the cover from the eld wiring compartment
with a phillips screwdriver. Feed the Power Supply Cable
through the electrical knockout. Connect the Power Supply
Cable to the rangehood cable. Attach the White lead of the
power supply to the White lead of the rangehood with a twist-
on type wire connector. Attach the Black lead of the power
supply to the Black lead of the rangehood with a twist-on type
wire connector. Attach the Power Supply Cable grounding
lead to the green screw provided. Using the 4 holes provided
screw the eld wiring compartment to the wall or cabinet as
dictated by your Power Supply Cable location (screws not
provided). Replace the cover.
7. Replace the grease lters.
8. Connect the ductwork to the damper and seal all con-
nections with duct tape.
9. Turn the power supply on. Turn on the blower and light.
If the rangehood does not operate, check that the circuit
breaker is not tripped or the house fuse blown. If the unit still
does not operate, disconnect the power supply and check
that the wiring connections have been made properly.
Loading ...
Loading ...
Loading ...