Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
6
NOTICE:
While installing the new solder wire. Please take o the protective sheath and
contact tip of the MIG torch (see picture 1). Then press the Mig torch switch to let
the wire out till 3.5cm. At last assemble the protective sheath and contact tip back
(see picture 2 and 3). To avoid the wire block the contact tip.
SETTING UP THE WELD:
1. Make practice welds on pieces of scrap the same thickness as your intended
workpiece to practice the technique before welding anything of value.
2. Clean the weld surfaces thoroughly with a wire brush or angle grinder; there must
be no rust, paint, oil, or other materials on the weld surfaces, only bare metal.
3. Use clamps (not included) to hold the workpieces in position so that you can
concentrate on proper welding techniques. The distance (if any) between the two
workpieces must be controlled properly to allow the weld to hold both sides
securely while allowing the weld to penetrate fully into the joint. The edges of
thicker workpieces may need to be chamfered (or beveled) to allow proper weld
penetration.
Protective sheath
Solder wire
Contact tip
Picture 1
Contact tip
Protective sheath
Solder wire
Picture 2
Picture 3
Loading ...
Loading ...
Loading ...