Loading ...
Loading ...
Loading ...
LuxProducts.com | 13
Step 3.5: Separate KONO Smart from its base.
Pull the wires from your wall through the center
hole of the KONO Smart base. Secure the base to
the wall using the included mounng hardware.
Step 3.6: Following the terminal labels marked
“Power Bridge” on the thermostat base,
press the lever and insert each labeled wire
into the top hole of the corresponding
terminal. Connect as follows:
• Y Wire Terminal 1
• W Wire Terminal 2
• R Wire Terminal 3
• G Wire Terminal 4
Step 3.7: Securely fasten KONO Smart
onto its base.
Step 3.8: Go to your furnace – remove the door
or panel and locate your control board or transformer. In most cases,
there should be four wires running from the furnace to your thermostat
– Y, G, W, and R. If you have addional wires, leave them as is.
INSTALLATION WITHOUT
C-WIRE3.
CONVENTIONAL C W1 W2
HEAT PUMP C W1 OB
POWER BRIDGE 1 4 2
Loading ...
Loading ...
Loading ...