Loading ...
Loading ...
Loading ...
18
Operating the Dishwasher
NOTE: For models with hidden controls, the door must be opened before changing
settings and closed after changing settings.
Buttons are sensitive and should be touched gently. Avoid any grease or food par-
ticles resting on the buttons as they could activate the dishwasher. Wiping and
cleaning can also activate the dishwasher. For best results, use bare, clean hands
when touching the buttons.
WARNING
To avoid risk of injury, always use caution when opening the door during
or following a wash cycle as hot water or steam may escape. Do not fully
open the door until water noises have stopped and steam has subsided.
Start the dishwasher
1 Press the [On/Off] button. The LED of the last selected cycle flashes.
2 Select a cycle and desired options and press [Start].
Cancel a cycle
1 Press and hold the [Start] button for approximately 3 seconds until
the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a cycle
1 Press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01 = 1 hour delay h:24 = 24 hour delay
To cancel delay start:
1 Press the [Delay] button until “h:00” is indicated on the digital display.
2 Press [Start] to save setting.
Cycle Completion Signal (hidden controls only)
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 16) and press [Start] until the
display indicates “d:00”. Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4 Press the “C” button to increase or decrease the tone “b:00” = OFF
and “b:03” = LOUDEST and press [Start] to save setting and close the
door.
Loading ...
Loading ...
Loading ...