Loading ...
Loading ...
Loading ...
Problem solving guide
80
Fault messages at the end of a programme
Message Possible cause and remedy
Check filter + jets
The pumps are dirty.
Clean the pumps as described in “Problem solving
guide - Opening the door in the event of a blocked
drain outlet and/or power cut”.
Restart the programme after cleaning the pumps.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the programme after cleaning the jet.
If the fault message appears again, contact Miele.
The washer-dryer can still be used but with reduced
functionality.
Hygiene info
A programme using a temperature above 60°C has
not been run for a long time.
In order to prevent bacteria and unpleasant odours
building up in the machine, run the Clean machine
programme using the Miele dishwasher and
washing machine cleaner or powder detergent.
Check detergent
Excessive foam has built up during washing.
Check the amount of detergent dispensed.
With automatic detergent dispensing, check the
dosage amount set.
Observe the instructions on the detergent
packaging and the degree of soiling of the laundry.
If necessary, reduce the dosage amount by
increments of 10%.
The messages will appear at the end of the programme and when the washer-
dryer is switched on and need to be confirmed with the OK sensor.
Loading ...
Loading ...
Loading ...