Loading ...
Loading ...
Loading ...
ENGLISH
|
15
Unit fails to heat up. Lighted On/
Off Switch DOES NOT illuminate
when set to “ON” position.
Unit fails to heat up. Lighted On/
Off Switch DOES illuminate when
set to “ON” position.
Steam output is weak
or intermittent.
Excessive amount of water
in steam.
NOTE: Unit produces wet steam
– it is normal for steam to
contain some amount of water.
Unit is not plugged in.
Mineral build-up in unit.
Mineral build-up in unit.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Unit is damaged or otherwise in
need of repair.
Water level in Water Reservoir is
running low.
Water Reservoir is empty.
Water condensation in
Steam Hose.
Water Reservoir has
been overlled.
Plug power cord into electrical outlet.
Refer to Mineral Build-up section
on Page 14 for cleaning procedure.
Refer to Mineral Build-up section
on Page 14 for cleaning procedure.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance
(see Page 16 for details).
Refer to Filling Water Reservoir
procedure on Page 11.
Refer to Filling Water Reservoir
procedure on Page 11.
Point nozzle towards sink, tub or
ground and shake while pressing
Steam Button. Continue until
excess water is released.
Filling Water Reservoir with more
than 48 oz. (1,420 ml.) of water
interferes with steam production,
resulting in water condensation
in steam.
Always use included Measuring
Cup to ll unit with correct amount
of water. (see Page 11 for details)
PROBLEM POSSIBLE CAUSE SOLUTION
Accessories do not stay rmly
connected to Main Nozzle.
Accessories not properly installed.
Unit has not heated to full
operating temperature.
Check to make sure that acces-
sories are properly connected, per
procedures on Pages 6-9.
Wait until Steam Ready Light
turns off to begin steaming.
Floor surfaces appear cloudy or
streaky after steaming.
Microber Pad is dirty.
Hard water residue on oor.
Replace Microber Pad with a
clean one.
Switch to distilled or
de-mineralized water.
Troubleshooting
Loading ...
Loading ...
Loading ...