Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 93
Bed Rail Tie-Down System — If Equipped
NOTE:
This feature is available for vehicles both
equipped, or not equipped, with a RamBox.
There are two adjustable cleats on each side of
the bed that can be used to assist in securing
cargo.
Adjustable Cleats
Each cleat must be located and tightened down
in one of the detents, along either rail, in order
to keep cargo properly secure.
To move the cleat to any position on the rail,
turn the nut counterclockwise, approximately
three turns. Then pull out on the cleat and slide
it to the detent nearest the desired location.
Make sure the cleat is seated in the detent and
tighten the nut.
Adjustable Cleat Assembly
Cleat Removal (Standard Box Rail)
To remove the cleats from the utility rail, slide
the cleat forward to access the cut out at the
end of the box rail, then remove the cleat.
Cleat Removal (With Tonneau Cover)
To remove the cleats from the utility rail, remove
the end cap screw located in the center of the
end cap, using a #T30 Torx head driver.
Remove the end cap and slide the cleat off the
end of the rail.
End Cap Screw Location If Equipped With
Tonneau Cover
CAUTION!
The maximum load per cleat should not
exceed 250 lbs (113 kg) and the angle of the
load on each cleat should not exceed
45 degrees above horizontal, or damage to
the cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
2
20_DS_OM_EN_USC_t.book Page 93
Loading ...
Loading ...
Loading ...