Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
CONNECT TO THE POWER SUPPLY
The washer should be plugged into a 120-VAC, 60-
Hz grounded 3-prong outlet. Plug in the washer.
Improper connection of the equipment-grounding
conductor can result in risk of electric shock. Check
with a qualified electrician or service technician
if you are in doubt as to whether the appliance is
properly grounded. Do not modify the plug pro-
vided with the appliance. If it does not fit the outlet,
have a proper outlet installed by a qualified electri-
cian. Failure to follow these warnings can cause
serious injury, fire, electrical shock, or death.
y
The power outlet must be within 60 inches (1.5
m) of either side of the washer.
y
The appliance and outlet must be positioned so
that the plug is easily accessible.
y
Do not overload the outlet with more than one
appliance.
y
The outlet must be grounded in accordance
with current wiring codes and regulations.
y
Time-delay fuse or circuit breaker is
recommended.
y
It is the personal responsibility and obligation
of the product owner to have a proper outlet
installed by a qualified electrician.
y
Do not use a worn or damaged power cord or
power plug. Replace or repair it immediately.
Failure to do so may result in death, fire, electric
shock, or malfunction.
y
Do not modify the power cord and take care
not to damage it when installing or moving the
washing machine.
Failure to do so may result in
death, fire, electric shock, or malfunction.
y
Make sure that the washing machine is
grounded.
y
Connect this washing machine to a grounded
outlet conforming to the rating prior to use.
Failure to do so may result in fire, electric
shock, or malfunction.
y
Do not use adaptors or extension cords.
The
washing machine should always be plugged
into its own individual electrical outlet which has
a voltage rating that matches the rating plate.
Failure to do so may result in fire, electric shock
or disorder.
y
Do not damage or cut off the ground prong of
the power cord.
Doing so may cause death,
fire, electric shock, or product malfunction.
WARNING
Installation Test
Once you have completed the installation of the washer,
use this test mode to make sure the water inlet hoses
and drain hose are installed and operating properly.
NOTE:
y The washer should be empty before starting this
test. Remove any packing materials or clothing from
the drum before starting the test.
TESTING THE WASHER
1
Make sure the drum is empty. Do not load any-
thing in the drum for this test.
2
Press the Power button then immediately
press and hold both the Spin and Soil buttons
until an code appears in the display.
(See below for a key to the codes.)
Display Information
Initial test
Previous test
result was good.
Previous test was
ended by error.
3
Press the START/PAUSE button.
The washer will start the test, which will last about
3 minutes. The test automatically checks the water
inlet hoses and the drain hose.
4
Check the display for results.
During the test, monitor the display. If an error
code is displayed, refer to the following guide.
Fully open the water faucets. Straight-
en out any kinks in the inlet hoses and
make sure the hoses are not pinned
against the wall or under the washer.
Straighten out any kinks in the drain hose
and make sure the hose is not pinned
against the wall or under the washer.
Remove and flush out the drain hose to
remove clogs. Adjust or repair the drain.
Maximum drain height is 96 inches (8 ft.).
5
End of cycle.
At the end of the test cycle,
will dis-
play. The test cycle will end and the washed
will shut off automatically after a short delay.
MFL39760288_E_A5.indd 12 2017. 9. 14. 오후 4:04
Loading ...
Loading ...
Loading ...