Loading ...
Loading ...
Loading ...
64
ENGLISH
Note:
These problems can be considered normal if the co ee blend has been
changed or if the machine has just been installed. In this case wait until the
machine performs a self-adjusting operation as described in section "Saeco
Adapting System".
Machine actions Causes Solutions
Co ee is too weak
(see note).
This might occur when the machine is
automatically adjusting the dose.
Brew a few co ees as described in chap-
ter “Saeco Adapting System”.
The co ee is too coarse. Change co ee blend or adjust the grind
as explained in chapter "Adjusting the
Ceramic Co ee Grinder".
The co ee bean hopper selector has
been shifted.
Switch the selector to the “
” position.
Co ee is brewed slowly
(see note).
The co ee grind is too ne. Change co ee blend or adjust the grind
as explained in chapter “Adjusting the
Ceramic Co ee Grinder”.
Circuits clogged. Perform a descaling cycle.
The circuit is not primed. Prime the circuit (chapter “Using the
machine for the rst time”).
The brew group is dirty. Clean the brew group ("Weekly Cleaning
of the Brew Group" chapter).
Co ee leaks out of the dispensing
spout.
The dispensing spout is clogged. Clean the dispensing spout and its holes.
The selector is locked. Some co ee beans may have got stuck. Move the selector and repeat this move-
ment until the bean is released.
The co ee bean hopper cannot
be inserted.
The blade placed under the co ee
bean hopper has been shifted.
Shift the blade to the end of its guide
covering the hole.
There may be some co ee beans left in
the co ee bean hopper compartment.
Remove the beans.
The selector is not in the correct posi-
tion.
Put the selector in the open position.
Co ee does not taste according
to the new beans.
You have not emptied the co ee duct
and grinder.
You need to brew at least two co ees be-
fore you can taste the new co ee beans.
The milk was not frothed. The automatic milk frother has been
inserted too far. No milk is being
sucked.
Let the Automatic Milk Frother cool
down. Slightly move it downwards. Place
it back in its proper seat.
The frothed milk is too cold. The cups are cold. Preheat the cups with hot water.
The
is displayed.
The co ee bean hopper selector has
been shifted.
Switch the selector to the “
” position.
The co ee bean hopper and tray are
dirty.
Clean the co ee bean hopper and tray
from any co ee residuals. (Chapter
“Weekly cleaning of the co ee bean hop-
per, the tray and the compartment)
Loading ...
Loading ...
Loading ...