Loading ...
Loading ...
Loading ...
17
2 Preparation
Precondition:The start screen is displayed.
T Place a cup under the fine foam frother.
T Press the
‘Milk foam’ button.
‘Milk foam’
As soon as the machine has heated up, ‘Switch open’ appears.
T Turn the switch to thex position.
‘Milk foam’, the milk foam is prepared. Preparation stops
automatically when the preset amount of milk is reached.
‘Switch close’
T Turn the switch to the °position.
Your JURA is once more ready for use.
To ensure that the fine foam frother always works properly, you
must clean it daily when you have been preparing milk (see Chap-
ter 5 ‘Maintenance – Cleaning the fine foam frother’).
It is easy to permanently adjust the amount of water for all single
products to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example: Proceed as follows to permanently set the amount of
water for one coffee.
Precondition:The start screen is displayed. Milk is connected to the
fine foam frother
T Place a cup under the coffee spout.
T Press and hold the
‘Coffee’ button until ‘Enough coffee?
Press button’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
T Press any button (except
‘Cancel’) as soon as there is suffi-
cient coffee in the cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
Your JURA is once more ready for use.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amounts for all single prod-
ucts in programming mode (see Chapter 4 ‘Permanent set-
tings in programming mode – Adjusting the product settings’).
Milk foam
Permanently setting the
amount of water for the
cup size
Loading ...
Loading ...
Loading ...