Loading ...
Loading ...
Continued on Next Page
SB-GM-TAHOSCNSL/10W3v2_INSTR_SKU#011220
SB-GM-TAHOSCNSL/10W3v2_INSTR_SKU#011220
STEP 15A
With the center console out of the vehicle, cut off the tabs
that protrude down from the cup holder area.
STEP 14
Remove the center console from the vehicle.
STEP 13
Remove the pair of screws that are found on each side of the
center console.
If the seat(s) are powered, bring the seat(s) to their highest
height and all the back to access the front screws. Bring the
seats all the way forward to access the rear screws.
If the seat(s) are manual, bring the seat(s) all the way back
and access the screws from under the seats, as in the picture.
STEP 12
Remove the wiring harness that is secured to the passenger
side of the center console.
Page 3 • JL Audio, Inc 2006
STEP 16
Cut out a pair of 2-inch x 2-inch squares, out of the carpet.
Driver side:
4-inches from the driver’s side tape line to the right.
7 1/4-inches from the rear of the hump (that runs the width
of the transmission hump) forward.
Passenger side:
1 1/2-inches from the passenger’s tape line to the left.
7 1/4-inches from the rear of the hump (that runs the width
of the transmission hump) forward.
STEP 18
Thread the supplied pair of socket cup set screws into the
bottom of the Stealthbox®, leaving 3/4-inches exposed.
STEP 17
Place the supplied pair of wax squares onto the areas that
were cut out in STEP 16.
STEP 15B
The opening with the tabs cut off.
4-inches
1 1/2-inches
7 1/4-inches
7 1/4-inches
Loading ...
Loading ...