Loading ...
Loading ...
Loading ...
6
INSTALLATION SVS CYLINDER SUBWOOFERS
SVS Cylinder Subwoofers – Base Plate Removed:
1. Using a helper as needed, lay the cylinder subwoofer sideways on a stable surface.
Take care to avoid damaging the amplifier.
2. Peel off the original equipment (OE) rubber disc feet.
3. Remove the OE machine screws. Support the base plate as needed to prevent it from
inadvertently dislodging while removing the screws. Important Notice: - If you are using a
powered bit driver to remove and/or install the machine screws, avoid excessive downward
pressure on the screw, as that may dislodge the t-nut mounted to the backside of the
woofer end-cap
4. Remove the base plate and the dowels and set aside.
5. Gather all of the 51 mm long machine screws from the Isolation System kit. There are
two (2) thread sizes provided – ¼-20 and M6.
6. Compare the OE feet machine screws to the
Isolation System 51 mm long machine screws
and select the matching/correct thread size.
7. Install each Isolation foot by inserting the
51 mm long machine screw through the bottom
opening of the rubber foot, through the opening
in the steel outer shell and into the t-nut on the
backside of the woofer end-cap.
8. Make sure the machine screw is correctly
aligned and does not cross-thread.
9. Tighten the machine screw avoiding
excessive downward pressure. Once the screw
fully tightens and starts to pull against the
end-cap t-nut, tighten securely using hand-
pressure.
10. Using a helper (if needed) carefully stand
the cylinder subwoofer back onto the installed
Isolation feet. Take care to avoid damaging the
amplifier.
Important Notice: - Do not drag the subwoofer base
plate across the flooring with the Isolation feet
installed. This may damage the Isolation feet or the
base plate. If you need to move the subwoofer, always
lift (use a helper if needed) the subwoofer and then
place it into the new location.
Loading ...
Loading ...
Loading ...