Loading ...
Loading ...
Loading ...
EN 58
Wired connection
1. Switch on the router and switch on its
DHCP setting.
2. Connect the router to the TV with an
Ethernet cable.
3. Press , then select [Setup].
4. Select [Connect to network], then press
OK.
5. Follow the onscreen instructions to install
the network.
6. Wait for the TV to find the network
connection.
7. If you are prompted, agree to the End
User Licence Agreement.
Wi-Fi ready
This section is for PFL32x8 only.
With the Philips wireless USB adapter
PTA128 (sold separately), you can connect
the TV to your home network wirelessly.
Note:
The wireless network operates in the same
2.4GHz frequency spectrum as common
household devices, such as Dect phones,
microwave ovens or Bluetooth devices,
which can cause Wi-Fi interference. Move
these devices away from the TV.
To reduce network traffic, switch off
unused network equipment in the
home network.
Reception quality depends on the
location of the wireless router and the
local Internet service provider.
When playing video over your wireless
home network, we recommend that
you use an IEEE 802.11 N router. The
connection speed may differ according
to the operating environment of your
wireless home network.
Start wireless setup
1. Switch on your wireless network router.
2. Connect the Philips USB adapter PTA128
to a USB connector on the TV.
The wireless installation starts automatically.
3. Follow the onscreen instructions.
Tip: Keep the wireless USB adapter
connected to the TV.
WPS - Wi-Fi Protected Setup
1. If your router supports Wi-Fi Protected
Setup (WPS), press the WPS button on the
router.
2. After 2 minutes, select [WPS] on the TV,
then press OK.
The TV connects to your network. This
takes about 2 minutes.
Most new wireless routers have the WPS
system and carry the WPS logo. The WPS
system uses WPS security encryption and
cannot be combined with devices on your
network that use the WEP security
encryption. If you still need the WEP (Wired
Equivalent Privacy) devices in your network,
install with [Scan] > [Custom].
Scan for routers
If you have several routers in your network,
you can select the network you need.
1. To select a specific network router, press
[Scan] on the first page of the installation.
The routers with WPS and the strongest
signal are shown first in the list on screen.
2. Select the router you need, then press
OK.
If you are connecting to a WPS router,
select [WPS] on the TV.
If you want to set the PIN code in your
router software to connect, select
[WPS pin]and note down the code.
To enter the encryption key manually,
select [Standard], then enter the key
when prompted.
Set secured connection with WPS PIN
1. To set secured connection, select the
[WPS pin] and press OK.
2. Write down the 8-digit PIN code shown
on TV, then enter it into the router software
on your PC.
To find out where to enter the PIN code,
read the router manual.
Loading ...
Loading ...
Loading ...