Loading ...
Loading ...
Loading ...
38
en Initial use
C start/stop
Press C for either beverage preparation
or to launch a service programme�
Press C again while the drink is being
prepared to prematurely halt dispensing�
There are four menu elds in the control
panel which can be activated by touching�
The active menu eld lights up red.
m
m lights up as soon as the
appliance is in operation� Drinks can be
selected and dispensed or settings for the
drinks can be changed�
B MyCoee
Touch B to open the selection of
“ Personalised beverage preparation”�
Personal settings for coee drinks can
be saved and called up (see the section
“ Personalised drinks”)�
A Menu
Touch A to call up the menu� Settings
can be made, information called up or the
appliance connected with “Home Connect”
(see section “Menu”)�
E Service
Touch E to open the selection of service
programmes. Run the desired programme
as described in the section “Service
programmes”�
F
Press A, E or B again to exit
the respective menu�
Control ring
Turn the control ring to navigate in the
display or to change parameters�
Information display
The round display shows the drink selected,
the settings or information�
Touch display (left and right)
Depending on the setting, dierent elds
are shon in both the touch displays. A eld
is activated when touched either to enter
settings or change values�
Initial use
General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use coee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit�
A
Before the appliance can be switched
on and used, it must be assembled
and connected according to the
enclosed assembly instructions�
Setting up the appliance
■ Remove any protective plastic lm.
F
Important: Only use the appliance
in a frost-free room� If it has been
transported or stored at tempera-
tures below 0°C, wait at least 3 hours
before initial use�
■ Take hold of the appliance door by the
recessed grip and open�
■ Remove the water tank, rinse it and ll it
with fresh water up to the “max�” mark�
■ Replace the water tank and click into
place�
■ Remove the bean container, ll with
coee beans and replace.
■ Set the mains switch to I and close
the appliance door�
The appliance heats up and is rinsed�
The control panel is activated�
“Language” appears�
■ Turn the control ring with your nger to
select the desired language and touch the
[ Water hardness ] eld.
Loading ...
Loading ...
Loading ...