Loading ...
Loading ...
Loading ...
en Additional programme settings
30
and counted down until the washing
programme starts. The duration of the
programme is then displayed.
Note: The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings, foam detection
function, unbalanced load detection, the
load or soiling may also change the
programme duration.
After the programme starts, and while
the selected time is counting down, you
can change this as follows:
1. Touch the control panel A.
2. Touch N or M to change the time.
3. And touch A again.
After starting the programme, while the
programme is running, you can add or
remove laundry if necessary.
~ Page 34
Memory programme
â
You can save a selected programme
with your favourite settings here.
To store:
1. Switch on the appliance.
2. Select a programme.
3. Change the settings and/or select
additional settings.
4. Press and hold â on the control
panel for approx. three seconds.
The programme is saved if all of the
settings flash briefly.
To use the saved programme, touch â
briefly after you switch on the appliance.
To change the saved programme, press
and hold â again for approx. three
seconds after selecting the new
settings.
\ Additional programme
settings
Additional programme settings
You can find an overview of all of the
additional settings that can be selected
depending on the programme on the
printed supplement to the installation
and operating instructions.
Aqua Plus
O
Adjustment values:
Higher water level and additional rinse
cycles depending on the programme,
longer programme duration for
particularly sensitive skin and/or for
areas with very soft water.
The number of rinse cycles that the
appliance actually runs depends on the
number that is set as a basic setting for
the program in question.
SpeedPerfect
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more energy
than, the selected programme, without
the SpeedPerfect setting.
Note: Do not exceed the maximum
load.
+1 + 1 rinse
+2 + 2 rinses
+3 + 3 rinses
off Setting deselected
Loading ...
Loading ...
Loading ...