SYN-DX-2.3 HP User Manual

Loading ...

AMPLIFIER SIGNAL INPUTS

Connect the RCA outputs from the source unit into the inputs of the amplier. The

SYN-DX Series has 1 pair of inputs for each pair of channels.

SYN-DX 2 SYN-DX 4

SYN-DX 4

SYN-DX 6

SYN-DX 2 ADVANCED SUBWOOFER CONTROLS

The SYN-DX 2-Channel Amplier is equipped with additional features / controls

when using a subwoofer on this amplier. There is BASS BOOST and SUBSONIC

FILTER. For any assistance in setting this up, please contact Wet Sounds Technical

Support at 877-938-7757.

Wet Sounds SYN-DX Series Owner’s Manual

On the SYN-DX 4, there is 1 input selection switch. The switch is used to

designate 2 or 4 channel input. You can select FROM CH 1-2 when only using 1

set of RCA inputs to allow all 4 channels to have output from 1 set of RCAs (CH

1,2,3, & 4). You can select FROM CH 3-4 to use both sets of inputs.

On the SYN-DX 6, there are 2 different input selection switches. The rst is to

designate 2 or 4 channel input. You can select FROM CH 1-2 when only using 1

set of RCA inputs to allow all 4 channels to have output from 1 set of RCAs (CH

1,2,3, & 4). The next is to turn on or off the inputs for channels 5 & 6.(See below)

Ch 5 & 6 can be carried over from inputs 1 & 2 when you select FROM CH 1-2, or

a separate set of RCA cables can be used when you select FROM CH 5-6.

**NOTE if you only use the amplier in 2 channel input mode you will not

have fading capabilities between front and rear outputs.**

Loading ...

Wet Sounds SYN-DX-2.3 HP Series 2 Marine Amplifier