SYN-DX-2.3 HP User Manual

Loading ...

RUNNING THE WIRING CABLES

**Always keep the signal cable and the power cables separated to prevent the

possibility of inducing noise into the system**

Carefully run the power and the signal cables through the boat. Always keep all

the wire tight and tied down to prevent the power wire from shorting and reduce

the risk of re. A 4 AWG or larger wire should be used for power and ground

connections. We recommend a fuse to be installed on the power wire within 18

inches of the battery for safety.

AMPLIFIER CONNECTIONS

**Make sure that the +12 volt cable is NOT connected to the battery while making

any of the connections until all the connections and the fuse are installed**

Power Connections

The SYN-DX Series is designed for 4 AWG Power wire (+12 V) and Ground wire

(GND). You will need to prepare the wire by remove 5/8” on the protective shielding

on the power and ground wire. Then take a Phillips head screwdriver and back out

the screws on the terminal block. Insert the +12 volt wire into the +12V side of the

terminal block and then tighten the screw back into the terminal block. You will do

the same for the Ground wire. See below

REMOTE CONNECTION

This amplier is designed to accept a 12 AWG – 16 AWG wire input on the terminal

block for speaker outputs 1 and 2. (Diagram A). The Remote Turn-on is how the

amplier knows when to turn on and off. This is typically connected to the remote

output wire on an aftermarket radio. When connecting this amplier to a factory

radio, you will need to nd a +12 volt accessory wire that switches on and off with

the key.

Wet Sounds SYN-DX Series Owner’s Manual

Loading ...

Wet Sounds SYN-DX-2.3 HP Series 2 Marine Amplifier