Faber CYLN15SS / 110.0166.589 Cylindra

User Manual - Page 7

For CYLN15SS / 110.0166.589.

PDF File Manual, 20 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Version 07/11- Page 7
DUCTLESS INSTALLATIONS
1. Install provided PVC pipe directly on top of the motor, and
seal with tape. F in FIGURE 9.
2. Remove the pre cut piece at the top of the hood body
(FIGURE 7). Using 4 screws (D in FIGURE 8), to attach the
hood body to the support frame on the wall, cover screws with
(E screw covers in FIGURE 8).
3. Install the ductless grille and then the stainless ring above
it with 2 screws (H, I, J in FIGURE 10).
4. Install the charcoal filters (sold seperately) above the
perimetric comfort panel and the grease filter, see (FIGURE
11) for installation. Remove the grease filter and position the
charcoal filter with the pull tabs facing out and forward then
snap into place. Place grease filter back into place.
FIGURE 9
F
FIGURE 10
H
I
FIGURE 11
2. Remove the cover from the Field Wiring Compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout. (See FIGURE 12) Connect the Power
Supply Cable to the rangehood cable. Attach the White lead
of the power supply to the White lead of the rangehood with a
twist-on type wire connector. Attach the Black lead of the power
supply to the Black lead of the rangehood with a twist-on type
wire connector. Attach the Power Supply Cable grounding lead
to the green screw provided. Using the 4 holes provided screw
the Field Wiring Compartment to the wall as dictated by your
Power Supply Cable location (screws not provided). Replace
the cover. Next connect the control and lighting wires inside the
hood above the grease filters as seen in (FIGURE 13).
FIGURE 12
USE AND CARE
The inside area of the perimetric comfort panel can be cleaned
using a damp cloth and is opened by gently pulling the panel
down on he front side. The panel can be removed from the hood
by sliding the fixing pin to the side, see (FIGURE 14).
FIGURE 14
3. Turn the power supply on. Turn on blower and lights. If the
rangehood does not operate, check that the circuit breaker is
not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
J
1. Install the SS comfort panel as in FIGURE 14, to the bottom of
the hood. Slide the fixing pin to install the hinge into place and lock
the panel into place by pushing the panel up into the slot.
FOR ALL INSTALLATIONS
FIGURE 13
Loading ...
Loading ...
Loading ...