Loading ...
Loading ...
Loading ...
15
WOOD SMOKING GUIDE FOR MEATS
WOOD FLAVOR POULTRY FISH HAM BEEF PORK LAMB
Hickory
Pungent, smoky, bacon-like avor
Mesquite
Sweet and delicate avor
Alder
Delicate, wood smoke avor
Pecan
Bold and hearty avor
Maple
Sweet, subtle avor
Apple
Sweet, delicate avor
Cherry
Sweet, delicate avor
WARNING
COMBUSTION BY-PRODUCT PRODUCED WHEN USING THIS PRODUCT CONTAINS CHEMICALS
KNOWN TO THE STATE OF CALIFORNIA TO CAUSE BIRTH DEFECTS, OTHER REPRODUCTIVE
HARM, OR CANCER.
CALIFORNIA PROP 65
WARNING: THIS PRODUCT CONTAINS CHEMICALS, INCLUDING LEAD, KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. WASH HANDS
AFTER HANDLING.
REGULATOR, BURNER AND GAS VALVE CONNECTION & OPERATION
MATCH LIGHT INSTRUCTIONS
WARNING
PERFORM “SOAPY WATER TEST” BEFORE EACH USE. SEE “SOAPY WATER TEST” SECTION IN
MANUAL. EXTINGUISH ALL OPEN FLAMES BEFORE CONNECTING REGULATOR TO GAS
CYLINDER. TURN GAS OFF AFTER EACH USE.
• Inspect hose before each use. If there are signs of wear, cuts, or leaks, replace
unit. DO NOT USE.
• Inspect burner before each use. Check burner and burner venturi tube for
insects and insect nests. A clogged tube can lead to a re beneath appliance.
• Connect hose regulator to LP Gas Cylinder
1. Make sure gas cylinder valve is closed. Turn knob clockwise until it stops.
2. Make sure control knob on smoker is in the “OFF” position.
3. Remove protective cap from gas cylinder and coupling nut if applicable.
4. Center and insert regulator nipple into valve outlet on gas cylinder as
shown in gure on the left. Turn regulator coupling nut clockwise until it
stops. DO NOT OVER TIGHTEN.
• Perform Soapy Water Test.
• To use turn gas cylinder ON, turn burner control knob clockwise and push ignitor
button to light.
• If ignition does not take place within ve seconds, turn gas control valve to off posi-
tion and wait ve minutes and repeat lighting procedures. If ignition still does not
occur, see match light directions below.
After use turn burner control knob OFF, then turn gas cylinder OFF.
• Burner control knob adjusts burner ame. Turn control knob clockwise SLOWLY to
increase ame. Turn control knob counter-clockwise to decrease ame and shut
ame off.
• Visually check burner ame. A CORRECT FLAME should be blue with a small
amount of yellow at the tip. An INCORRECT FLAME is excessively yellow and
irregular. If an incorrect ame occurs, turn burner control knob to “OFF position,
turn off regulator and propane tank. Allow unit to cool and then clean burner.
Let burner completely dry before re-lighting.
CLOCKWISE
COUNTER
CLOCKWISE
17.75”
(45cm)
APPROX.
12.25” (45cm)
APPROX.
YELLOW
BLUE
1. Read all instructions and warnings before lighting.
2. Check gas control valve and gas cylinder valve to be certain it is in
OFF position before connecting to gas cylinder. Perform soapy
water test before each use.
3. Open door during lighting.
4. Turn gas control valve on, turn gas cylinder valve on.
5. Place a long, lit replace match stick close enough to burner to
ignite.
6. After each use, rst turn gas control valve off, then gas cylinder
valve off. Always allow unit to cool completely before touching,
moving or storing.
4
Loading ...
Loading ...
Loading ...