Loading ...
2
WARNING:
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR PERSONAL INJURY
• DO NOT USE AN EXTENSION CORD
WITH THIS APPLIANCE.
• THIS APPLIANCE MUST BE PROPERLY
GROUNDED (EARTHED).
Dryer must be electrically grounded (earthed) in
accordance with local codes and ordinances.
Electrical requirements:
• The operating voltage (volts), amperage (amps) or
wattage (watts) and frequency (Hz) of your dryer are
indicated on the rating plate located on the upper
right corner of the door opening.
• The dryer must be connected to an individual branch
circuit corresponding to that indicated on the rating
plate and protected by the required time-delay fuses or
circuit breakers in accordance with governing codes.
• If the electrical supply does not meet what is indicated
on the rating plate, call a licensed electrician.
IF THE DRYER IS SUPPLIED WITH A FLEXIBLE POWER CORD
Plug the cordset into its own separate grounded outlet. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE GROUND PRONG FROM THE POWER CORD.
1. Remove cover near the power supply entry hole.
2. Install 3/4 inch, recognized strain relief to power entry
hole. Bring power supply through strain relief.
3. Connect power supply as follows:
A. Live (brown) line to upper screw of terminal block
(marked L1).
B. Neutral (blue) line to center screw of terminal block
(marked N).
4. Attach ground (earth) wire (green, green and
yellow, or bare) to the green ground screw (hole
above strain relief bracket). Tighten all terminal
block screws firmly.
5. Properly secure power supply to strain relief.
6. Reinstall the cover.
Electrical Connection Information
MAKE SURE SCREWS ARE
PROPERLY TIGHTENED
BLUE
BROWN
USE PROPER
STRAIN RELIEF
POWER SUPPLY CORD
220/240 VAC 30A
ASSURE GROUND (EARTH) WIRE
IS PROPERLY CONNECTED
WIRING DIAGRAM AND SOME SERVICE INFORMATION LOCATED IN CONTROL HOUSING
IF THE DRYER IS SUPPLIED WITH A TERMINAL BLOCK
WARNING: NEVER LEAVE THE TERMINAL BLOCK WITHOUT THE COVER.
STRAIN RELIEF
BRACKET
Loading ...
Loading ...