Loading ...
Loading ...
Loading ...
©2019 Hestan Commercial Corporation
15
EN
GAS CONNECTION - LIQUID PROPANE (LP) CYLINDER
Your Hestan grill for use with LP gas is supplied with a two-stage regulator/hose assembly for
connection to a standard 20 lb. LP gas cylinder (not included). This assembly is pre-installed and
must be used WITHOUT alteration. If this assembly needs to be replaced, contact your Hestan
dealer for genuine replacement P/N 014309.
NOTE: To ensure proper heating performance of this appliance, verify that the supply (inlet)
pressure is adequate. Use only the gas pressure regulator supplied with this appliance. This
regulator is set to maintain 10 inch WC [2.49 kPa] nominal outlet (manifold) pressure. To connect
the regulator / hose assembly follow these steps:
1. Connect the regulator/hose assembly to a standard 20 lb. LP cylinder. The hose as well as the
connectors must comply with the
Standard for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75 • CSA 6.27
, and suitable for outdoor installation. Use the
appropriate thread sealant on all thread connections.
2. Observe the notes about proper tank and hose placement in LP DELUXE GRILL on pg. 13.
3. Proceed to LEAK TESTING section.
GAS CONNECTION - LP PIPED SYSTEMS
An LP piped system is one with a large central LP tank that feeds an entire household. These
systems are normally equipped with a high pressure regulator by the large LP tank, and low
pressure regulators close to the home. The gas line connectors must comply with the
Standard for
Connectors for Outdoor Gas Appliances and Manufactured Homes, ANSI Z21.75 • CSA 6.27
, and
suitable for outdoor installation. The connection to your grill is via the 10 ft [3 m] hose discussed
in the NG section on pg. 14.
If you have an LP grill, please contact Hestan Customer Service to order an LP Piped System Kit
for this unique installation. If you have a NG grill and are converting to an LP Piped System, please
supply this information to receive the correct kit.
Follow the same hose assembly/connection instructions given on the previous page, followed by
leak testing.
NOTE: To ensure proper heating performance of this appliance, verify that the supply (inlet)
pressure is adequate (11-14 inch WC [2.74-3.48 kPa] pressure is preferred) to maintain 10 inch WC
[2.49 kPa] nominal outlet (manifold) pressure.
GAS CONNECTIONS
(continued)
Loading ...
Loading ...
Loading ...