Loading ...
Loading ...
Loading ...
32
2. Check the batteries to make sure that they are new alkaline or lithium AA
batteries. See note above about short battery life.
3. Make sure that the camera power switch is in the “On” position and not in the
“Off” or “Setup” modes.
4. Make sure that you are using a good quality SD card in your camera. Bushnell
recommends SanDisk
®
SD Cards up to 32GB (Ultra
®
or Extreme
®
series
for HD video) .
5. If the SD card has its write protect switch in the lock position, the camera will
not take images.
6. If you have used an SD card in another device before inserting it in your
Trophy Cam HD Aggressor, you might want to try formatting the card using
the “Format” parameter in Setup mode (make sure you have backed up any
important files first, as formatting will erase all previous files). In some cases,
other devices may change the formatting of the SD card so that it will not work
properly with the Trophy Cam HD Aggressor.
Camera won’t power up
1. Make sure that you have installed 8 batteries in the battery compartment.
Bushnell recommends using Energizer
®
Lithium AA batteries in your
Trophy Cam HD Aggressor.
2. Make sure that the batteries are installed correctly, observing proper polarity.
Always place the negative (flat) end of each battery in contact with the spring
side of its slot inside the camera.
3. After moving the switch from “Off” to “Setup” or “On”, make sure that the
switch is correctly in position to ensure the proper mode (avoid positions
“between” two modes).
4. Do not move the switch directly from “On” to “Setup”-always move the switch
all the way down to “Off” first, then back up to “Setup”.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full. The flash will
stop operating near the end of the battery life.
b. You will get the best results when the subject is within the ideal flash range,
no farther than 80ft/24m (119876/119877) or 100 ft/30m (119874/119875).
Subjects may appear too dark at greater distances.
c. Please note that when the Capture Number parameter is set higher than "1
Loading ...
Loading ...
Loading ...