Bushnell 119874C User Manual

Loading ...

of time by pressing the DOWN key to select "B" (Step 4), then press OK and

follow the same process to set Start and Stop times for Field Scan block "B"

(Step 5). As an example of how you might use these two available time blocks,

you could setup Field Scan time block "A" for the dawn hours from 6 AM to 8

AM, and block "B" to capture images between 5:30 and 7 PM. No Field Scan

recording would occur from 8AM to 5:30PM, or from 7PM to 6AM.

6. After setting Start/Stop times to deﬁne Field Scan block "A" and/or "B", press

OK, then press the UP or DOWN key to select "Interval" and press OK (Step

6). The Field Scan "Interval" setting lets you control how often a photo or video

clip is recorded during the block(s) of time you deﬁned with the Start and Stop

settings. Your options are 60 minutes, 30 minutes, 15 minutes, 5 minutes

(default setting, also the lowest interval in video mode), or 1 minute (still photo

mode only). Use the UP/DOWN keys to select your preference, then press

OK to save it (Step 7). Note that for videos, "Interval" is independent of the

Length of each video recording-it’s how often videos are recorded, not how

long each one lasts.

7. Here’s an example of how the camera would operate, based on the following

Field Scan settings:

Field Scan: On

Field Scan A:

[Start]: 6:00

[Stop]: 8:00

Field Scan B:

[Start]: 17:30

[Stop]: 19:00

Interval: 15M

These settings would cause the camera to capture a photo (or video, if the

camera is set to that mode) once every 15 minutes, beginning at 6 AM, until the

Field Scan "A" recording block stops at 8:00 AM. Later that day, the camera

would again take a photo or video every 15 minutes between 5:30 PM and

7:00 PM (during Field Scan time block "B"). The next day, the camera would

again record an image or video once every 15 minutes between 6:00 and 8:00

AM, and between 5:30 and 7:00 PM. No Field Scan recording would occur

from 8AM to 5:30PM, or from 7PM to 6AM. Remember, Field Scan recording

is independent of normal triggers due to animal activity–even if no animals enter

Note: avoid any "overlap" of Field Scan A & B

recording blocks when setting their start and stop

times, to assure correct operation. Also-if the "Camera

Mode" menu parameter is set to "Day" or "Night"

operation only, that will take priority over your Field

Scan settings. Set the Camera Model to "24 HR" if

you are setting both day and night start and/or stop

times in Field Scan.

Loading ...

Bushnell 119874C Cameras