Loading ...
Loading ...
Loading ...
READ THE INSTRUCTION BOOKLET BEFORE INSTALLING AND
USING THE APPLIANCE.
The manufacturer will not be responsible for any damage to property or to persons
caused by incorrect installation or improper use of the appliance.
The manufacturer is not responsible for any inaccuracies, due to printing or transcription
errors, contained in this manual. In addition, the appearance of the figures reported is
also purely indicative.
The manufacturer reserves the right to make changes to its products when considered
necessary and useful, without affecting the essential safety and operating
characteristics.
Glen Dimplex constantly seeks ways to improve the specifications and
designs of their products.
Whilst every effort is made to produce up to date literature, this document should not
be regarded as an infallible guide. Actual product only should be used to derive cut out
sizes. All appliances must be installed by a qualified person/s with adherence to the
relevant electrical, plumbing and building codes, with compliance being issued as
required by state or national legislation.
Additionally, all upright cookers must have the anti-tilt device installed correctly in
adherence to the relevant standards by a licenced installer.
For maximum effectiveness and efficiency all rangehoods should be installed with the
use of ductwork, by a licenced installer with adherence to the relevant state and national
building codes and regulations.
All Glen Dimplex appliances are for Domestic use only, and must be installed by a
licence installer into Domestic Applications only, without exception and to the required
Authorities guidelines. Any installation outside of this will VOID warranty. Alfresco areas
are not a Domestic application.
Distributed by:
Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd
www.glendimplex.com.au www.glendimplex.co.nz
For service advice, please contact the Customer Care Centre by phone or email below.
Australia
Ph: 1300 556 816
New Zealand
Ph: 09 274 8265
VERSION1REVISION20201208