Loading ...
Loading ...
Loading ...
11
- Remove the central screw Fig.1A.
- Lift the electrical plant box Fig.1B.
- Remove the 3 fixed screws Fig.1C.
- Position the electrical box so it is in line with the holes of the previously removed screws
Fig.1D and tighten.
- Make sure that the protruding mounting tab of the electrical box is inside the slot and then
tighten screw Fig.1E.
• FIxingtothewall:
Drill the holes A respecting the distances indicated (Fig.3). Fix the appliance to the wall and align
it in horizontal position to the wall units. When the appliance has been adjusted, tightly secure
the hood using the screws A (Fig.5). For the various installations use screws and screw anchors
suited to the type of wall (e.g. reinforced concrete, plasterboard, etc.). If the screws and screw
anchors are provided with the product, check that they are suitable for the type of wall on
which the hood is to be xed.
• Regardingtheinstallationonplasterboardwall:
Make sure that the screws are well xed to the bearing elements of the wall. If that is not
possible, it is necessary to install a carrying support structure made by joists from 2 to 4 inches
with the points of anchorage of the screws.
• Fixingthedecorativetelescopicue:
Arrange the electrical power supply within the dimensions of the decorative ue. If your appliance
is to be installed in the ducting version or in the version with external motor, prepare the air exhaust
opening. Adjust the width of the support bracket of the upper ue (Fig.4). Then x it near the ceiling
using the screws A (Fig.4) in such a way that it is in line with your hood and respecting the
distance from the ceiling indicated in Fig.3. Connect the ange C to the air exhaust hole using
a connection pipe (Fig.5). Insert the upper ue into the lower ue. Extract the upper ue up to
the bracket and x it with the screws B (Fig.4).
• Filteringversion(carbonltersonsomemodels)
Install the hood and the two ues as described in the paragraph for installation of the hood in
ducting version. To assemble the ltering ue refer to the instructions contained in the kit.
The lters must be applied to the suction unit positioned inside the hood. They must be centred
by turning them 90 degrees until the stop catch is tripped (Fig.6).
Loading ...
Loading ...
Loading ...