Maintenance Manual
INSPIRE 1
I. Checking the Battery
1. Check the battery for damage and deformities. If
there are any signs of damage to the battery, stop
using it and discharge the battery to 10% or below
for disposal. Do not disassemble the battery for any
reason.
2. Check the battery pins and rub them clean with an
eraser if any residue is observed. This will help to
ensure a more reliable connection.
3. Check the metal battery power connectors for
damage. If the connectors appear burnt, try to clear
them. This can be done by inserting a piece of
sandpaper (1mm thick) into the connectors to polish
the metal.
4. Check the contact pins in the battery compartment to
ensure that the pins are clear. They should be able
to establish easy contact with the battery connectors
and should not be bent.
5. Check the electrodes on the battery. If they appear
burnt, polish them with sandpaper. If there is serious
erosion, send the battery in for repairs.
6. Check the plastic components of the battery bracket
to see it is in good condition and that all screws are
secure. This prevents the battery from becoming
loose during ight.
7. Check the power cables between the arms and the
center plate, if the cables are worn, contact DJI to
arrange repairs.
8. For long term storage, please refer to the “Intelligent
Flight Battery Safety Guidelines” and check the
battery once a month to prevent the battery cell from
being damaged.
9. Run the DJI Pilot App to conrm that all battery cells
are at similar voltage levels and stay at the same level
when the battery is fully charged. If all cells maintain
voltage levels above 3.7V but any cell is 0.2V higher
or lower than the others, contact DJI for analysis. You
can also check the battery cell warning history. If any
warning are reported, contact DJI.
II. Checking the Transformation System
1. Check the servomotor cables for wear. Also conrm
that the connection points are still in good condition.
2. Check the lead screws and contact DJI Support
to arrange repairs if any bending or damage is
discovered. Clean the lead screws with WD-40 spray
if they show signs of rust.
3. Listen to the servomotors during the transformation,
if there is abnormal noise, it may indicate that the
servomotors worn.
4. After the landing gear rises, check the lead screws
and bearings. If any dirt or dust is found, clean and
grease the bearings.
5. Check the lead screws. If there is any scratches,
dents, or plastic particles underneath them, contact
DJI Support to arrange repairs.
III. Checking the Aircraft
1. Confirm that all the screws are still adequately
tightened.
2. Check the aircraft for breaks or damage. If there is
any reason to believe that detectable damage might
affect ight safety, consult with DJI Support.
3. Check the carbon tubes of the arms for damage.
4. Check the dampers on the landing gears. If they are
loose, secure them with 502 glue.
5. Ensure that there are no obstacles on or around the
GPS module or around the antennas on the landing
gear. Remove any obstacles (such as tapes with
conductive material) that might affect or block the
signal.
6. Check that the right and left landing gear rest at the
same tilt angle.
To ensure that your aircraft continues to offer optimal performance and to ensure flight safety,
it is recommended that comprehensive maintenance be performed after every 200 flights or 50
ight hours. This manual is intend to help users maintain their aircraft and maximize its continued
reliability.
2015.2
V1.0
©
2015 DJI. All Rights Reserved.
1
Loading ...
